Battery Characterisation and Management - the key to Smart Grids and the Integration of Electric Vehicles

ffe7d3ca-ed95-4723-bce8-acd2443fb1f9

Closed

EPSRC
EPSRC
EPSRC
EPSRC
EPSRC

£6,693,595

July 10, 2013

April 28, 2017

As recently as the 9th November 2012, the UK Chancellor, Mr George Osborne, stated in a speech to the Royal Society that "there is the challenge of storing more electricity for the Grid. Electricity demand peaks at around 60GW, whilst we have a grid capacity of around 80GW - but storage capacity of around just 3GW. Greater capability to store electricity is crucial for these power sources to be viable. It promises savings on UK energy spend of up to £10 billion a year by 2050 as extra capacity for peak load is less necessary." China, by contrast, has a grid capacity of over 1,000GW and an electrical demand growth rate of over 11% p.a, and in 2011 installed more wind capacity than the rest of the world put together. Concurrently, plans to clean up emissions from the transport sectors are leading to ambitious plans to expand the use of electric vehicles which will both challenge the electricity system due to the substantial need for battery charging, but also provide opportunity as these batteries can be used to provide energy storage.
Hence the challenge for both the UK and China is, recognising the current global EV market is forecast to grow from 1.7 million units in 2012 to 5.3 million units in 2020, how to utilise this massive aggregate electrical energy storage capacity from EV batteries to deliver essential power network services such as frequency support, load levelling, 'firming' of renewable generation and so forth. The dual use of such vehicle energy storage (to provide its core vehicle transportation duty and grid support when connected to the network for recharging) is referred to as Vehicle-to-Grid (V2G) operation. V2G has many technical challenges to overcome as well as requiring careful cost benefit analysis of the effect of increased charge/discharge cycling of the battery, and associated degradation, versus the grid support benefits achieved.
The dual use of EV batteries to provide grid support will make available very fast acting (<5 sec) and, crucially, low cost (Euro22/kW) aggregated energy storage, at cost levels significantly below dedicated grid battery installations (e.g. Euro3180/kW (@$1=Euro0.75) for the PGE 5MW, 1.25MWh Li-ion battery grid support project in Salem, Oregon, US) or competing energy storage technologies like compressed air energy storage (CAES).
Critically this proposal aims to focus on V2G operation from a battery perspective 'upwards' and not from a network level 'downwards', as the key factors relating to the success of V2G are those concerned with the battery technology. The research challenges identified with this work are:
1) Determining the anticipated patterns of battery cycling associated with driving and V2G operation for specified grid support functions e.g. frequency support, peak shaving etc.
2) Investigating the impact of the anticipated V2G operation on battery cell, module and pack cycle life, failures and thermal behaviour (i.e. thermal cycling and impact on cold/hot battery charging behaviour). Additionally more accurate determination of battery state of charge (SoC) and state of health (SoH) is required, including ensuring cell balance within the battery pack.
3) Investigating the communication and control temporal and physical information requirements from the battery management system (BMS) to the grid control system and vice versa.
4) Demonstrating V2G operation within distinct UK and Chinese environments, employing the new BMS software with cycling/thermal control, and improved SoC/SoH prediction.

Potential Impact:
At the heart of this UK-China research collaboration is the aspiration to encourage a technological, societal and economic impact to help address the apparently conflicting transport and energy sectors. To reduce greenhouse gas emissions, the energy sector seeks to utilise more renewable energy, which is inherently less controllable, and to reduce energy consumption. Conversely the transport sector seeks to reduce tailpipe emissions through technical change from petroleum fuels to electric vehicles, which has the net result of increasing the load on the electricity network and potentially increasing the peak load, requiring more controllable generation plant to satisfy this load. This international research collaboration aims to address such global challenges by delivering the following impact across a range of stakeholders:

Industry - Enhanced understanding of EV Batteries, via improved cycle life and safety management;
Supporting EV initiatives of the China Assoc. of Automobile Manufacturers and UK Automotive Council, via use and demonstration
of improved batteries;
Stakeholder engagement via consortium workshop events;
Electric Utilities and Renewable sector through applicability of V2G, as the lowest cost form of grid scale electrical energy storage,
to support grid/renewables development

Government - Supports climate change policy for reducing transport emissions, and EV targets;
Assist convergence towards renewable targets enabled via V2G grid support;
Supports UK 'key' technology within energy storage sector

Society - Demonstration of EV functionality and improved EV battery knowledge;
Reduced greenhouse gas emissions via increased EV uptake and V2G support of renewables